Filter
Top Products
20
Enhancements in Release F.05.05 through F.05.70
Enhancements in Release F.05.05 through F.05.60
See Figure 6 below for an example of adding an additional Syslog server.
Figure 6. Configuring multiple Syslog Servers
Operating Notes for Syslog
■ Rebooting the switch or pressing the Reset button resets the Debug Configuration. Any Syslog
server IP addresses written in the startup-config file are saved across a reboot and logging
remains enabled. Any Syslog server IP addresses existing only in the running-config file are lost
if the switch reboots. (Use the write memory command to save configuration changes to the
Startup-config file.)
■ Up to six Syslog servers may be configured to receive Event Log messages. All switches must
use the same Syslog facility.
Isolated Port Groups (Enhanced)
Isolated Port-Group Commands
[no] port-isolation page 25
port-isolation [ethernet] < port-list > mode
< uplink | public | group1 | group2 | private | local >
page 25
show port-isolation page 25
Continuing the example begun in
figure 2, this command adds a
second Syslog server.
Lists the IP addresses of the Syslog
servers configured on the switch.
Messages must be sent to the
same facility on each Syslog