Filter
Top Products
25
Enhancements in Release F.05.05 through F.05.70
Enhancements in Release F.05.05 through F.05.60
Configuring and Viewing Port-Isolation
Note
The no port-isolation command erases all port-isolation mode settings from memory. This means that
whenever you disable, then re-enable port isolation, all ports on the switch will be set to the (default)
Uplink mode.
Syntax: [ no ] port-isolation
Without any port-list or mode parameters, enables port isolation on the switch
and sets all ports to the Uplink mode. The no version disables port isolation and
also causes all individual ports to be set to the (default) Uplink mode the next time
you enable port isolation.
[ ethernet ] < port-list > mode < uplink | public | group1 | group2 | private | local >
Specifies the ports you want to configure to a particular port-isolation mode
(uplink—the default— public, group1, group2, private, local).
show port-isolation
Lists the switch’s port-isolation status and, if enabled, the port-isolation mode and
which ports, if any, are in a port trunk.
show running-config
Lists the switch’s running configuration, including port-isolation settings.
show config
Lists the switch’s startup configuration, including port-isolation settings.