Filter
Top Products
114 Chapter 4 - Problem solving
EN
ENVELOPE FEEDER
SIZE = [xxxxx]
The printer is asking what size of envelopes has been loaded in the
envelope feeder. In response, you can take either of the following
actions:
• press S
ELECT
to accept the current envelope size
• press -V
ALUE
+ to change the size and then press S
ELECT
to accept
the new size
If you do not press any buttons, the message disappears in about 1
minute.
Note
Changing the size here changes the default for envelope size in the
envelope feeder in the Paper Handling Menu (see the description of
“
ENVELOPE FEEDER SIZE=COM10
” on page 210).
ENVELOPE FEEDER
TYPE = [xxxxx]
The printer has received a job under the following conditions:
• the envelope type requested by the job is not available in the printer
• envelopes have just been placed in the envelope feeder (thus
triggering the paper sensor)
You can take either of the following actions:
• press S
ELECT
to accept the paper type and then press
G
O
• press +V
ALUE
- to change the type, press S
ELECT
to accept the new
type, and then press G
O
to continue
EXTERNAL DEVICE
INITIALIZING
When an external paper handling device is connected to the printer,
it must initialize after the computer boots or after coming out of
PowerSave mode.
FLASH DEVICE
FAILURE
The flash DIMM had a critical failure and no longer can be used.
Remove the flash DIMM and replace it with a new one.
FLASH FILE
OPERATION FAILED
The requested operation could not be performed. You might have
attempted an illegal operation, such as trying to download a file to a
non-existent directory.
FLASH FILE
SYSTEM IS FULL
Delete files from the flash DIMM. Use HP Resource Manager to
download or delete files and fonts. (See the software help for more
information.)
FLASH IS
WRITE PROTECTED
The flash DIMM is protected and no new files can be written to it.
Disable the write protection through HP Resource Manager.
Printer messages (continued)
Message Explanation or recommended action