Filter
Top Products
No
Disables load balancing. When disabled, then for a given source IP and destination IP
address, the same circuit is used for all packets.
Yes
Enables load balancing. When enabled, a circuit is randomly selected from the
circuit group for each packet.
Local ASN
The NIC-assigned decimal number that identifies the local autonomous system.
Enter the local autonomous system number.
Local Address
The IP address, in dotted-decimal notation, of the local EGP interface that
establishes the connection to the remote autonomous system.
Low Value (hex)
Sets the lower boundary range of the bit pattern when creating a user-defined filter.
Options
Enter the bit pattern (hexadecimal) in this field and leave the High Value (hex)
field blank if you are filtering a single bit pattern.
Enter the lowest bit pattern in this field and enter the highest bit pattern in the
High Value (hex) field. If you are filtering a range of bit patterns.
For more information, refer to “High Value (hex)” earlier in this chapter.
Make route conditional
on an alternate circuit
group
Determines whether to use conditional static routing.
Default: No
No
Disables conditional static routing.
Yes
Enables conditional static routing.
Note: When conditional static routing is enabled, the Conditional Circuit Group and
Action on circuit group enable/disable parameters are displayed. For more
information, refer to “Conditional Circuit Group” and “Action on circuit group
enable/disable.”
Management Priority
Enables immediate procession of SNMP traffic.
Default: Low
High
Causes the router to process all management traffic as it is received.
Note: Setting Management Priority to High can noticeably impact the routing of
non-management traffic.
Low
Gives priority to the normal routing of incoming non-management traffic.
Internet Protocol (IP) Parameters
Parameters and Options
7-18