Filter
Top Products
Action: Reconfigure both lines to have the same clock speed.
Internal clock must be the same on all ports
Meaning: On all HP series 200 and 400 routers, all synchronous lines share the
same clock signal generator. Thus, when using internal clocking on
more than one line, the Clock Speed parameter in the lines configuration
must have the same value for those lines. The Clock Speed parameter is
not used when the clock source for the line is set to External.
Action: Reconfigure both lines to have the same clock speed.
Internal clock set to
speed
Meaning: This is a progress message indicating what clock speed was chosen for
the indicated line. The chosen speed is not what was configured because
the line shares a clock signal generator with another line. For an HP
Router 650, lines using connectors WAN1 and WAN2 share a clock signal
generator, and lines using connectors WAN3 and WAN4 share a clock
signal generator. For all other products, all synchronous lines share a
clock signal generator.
Action: Reconfigure both lines to have the same clock speed.
Invalid MFS, dflt=2
Meaning: The configuration record for the circuit contains a faulty value in the
Minimum Frame Spacing field. The router has defaulted to a value of 2.
Action: Modify Minimum Frame Spacing in the configuration.
Invalid N2, dflt=16
Meaning: The configuration record for the circuit contains a faulty value in the
Retry Counter (N2) field. The router has defaulted to a value of 16.
Action: Modify Retry Counter (N2) in the configuration.
Event Log Messages
dev: Device Event Messages
17-64