Filter
Top Products
ipmapstate[map#] indicates the state of the IP map. The possible
states are the following:
disconnected means the map is disconnected; the circuit is
available.
disabled means the circuit has been disabled by NCL’s Disipmap
command.
connecting means the map is in the process of making a V.25 bis
connection.
connected means the map is connected and the circuit is in use.
queue wait means the map has data to send, but no pool circuits
are currently available. When a circuit becomes available, the map
will go into the connecting state. (Refer to the VC inactivity time
parameter in chapter 14.)
hold down means the map has failed to connect. It cannot be used
until the Hold down time expires. The IP address will again be
accessable and the map will go into the disconnected state. (Refer to
the Hold down time and VC inactivity time parameters in chapter 14.)
ipmapxmitpkt[map#] contains the number of packets successfully
transmitted for this map.
nexthop[map#] contains the address of the network that has a
static route through the next hop address. There is a separate entry for
each network reachable using the static route. That is, there can be
several entries per next hop (For this reason there is a separate instance
for each address). The format of the message associates the next hop
with the given address. (For example, ip_networks_1 indicates that
this IP address is associated with nexthop[1]).
Managment
Information Base
18
Management Information Base Variables
isdn: ISDN (V.25 bis) Information Base
18-73