Filter
Top Products
700
750C Plus
750C Plus
3-27
Company confidential. Murillo/Ravillo User’s Guide. Final Freeze Status: Frozen
This is the cyan on page 3-27 (seq: 103)
This is the black on page 3-27 (seq: 103)
Before Replacing Cartridge(s)
Four important points:
1 Your plotter is designed to operate only with the black cartridge whose specific part
number is listed on page 11-15.
Your plotter is designed to operate only with the four cartridge types whose
specific part numbers are listed on page 11-15. Except on glossy media types, the
plotter will operate successfully in monochrome with just the black cartridge
loaded, although the
Best print quality may not be as good as if all cartridges were
loaded. Otherwise, all four must be loaded.
2 Every time you replace, or even adjust, a cartridge, the plotter afterwards runs an
automatic alignment procedure, for which it needs an opaque media type, for
example opaque bond (regular plotter paper) or coated paper. So make sure that
either a roll or a sheet of the appropriate media is loaded before you replace a
cartridge. If the automatic cartridge alignment procedure is not run on a suitable
media type, print quality will be affected.
3 Once the cartridge(s) have been installed they should not be removed, except to
replace them. This will ensure the best lifetime for your cartridge(s).
4 Make sure you are aware of the general warning and cautions below.
Don’t touch the stainless steel strip that runs the length of the plotter behind
the cartridge carriage; its edge is very sharp. Keep hair, jewelry, clothing,
and foreign objects away from the plotter mechanisms. Keep new and used
print cartridge(s) out of the reach of children.
Only touch the plastic parts of the cartridge. Do not touch, wipe, or attempt to
clean the cartridge nozzles or contacts as they can become clogged or
scratched and are easily damaged.
Each time you access the cartridge(s) to load or reseat them, the nozzles are
exposed to air. If the nozzles are exposed to air (except during plotting) for
more than a few minutes at a time, they are susceptible to clogging and
drying.
With the HP DesignJet 750C Plus plotter, it is absolutely essential to load the
cartridge(s) in the correct stalls, or your colors will be wrong and print quality
may be impacted.
Working With Media and Cartridge(s)
Replacing Cartridge(s)
MEDIA AND
CARTRIDGES
3
WARNING
CAUTION
CAUTION
CAUTION