Filter
Top Products
3-12
Company confidential. Murillo/Ravillo User’s Guide. Final Freeze Status: Frozen
This is the cyan on page 3-12 (seq: 88)
This is the black on page 3-12 (seq: 88)
5
From the other end of the old media roll, pull out the endcap (B).
B
0022
6 If you are not immediately loading another roll of media into the plotter, replace
the endcap on the spindle and place the spindle back in the plotter. You can skip
the rest of these steps.
7
a Remove the new roll from its wrapping.
b Turn the spindle upside down, that is, with the media stop at the bottom (and
the end cap still removed)
c Place the new roll on the spindle, so that the leading edge winds clockwise.
If the media stop falls off, push it back
in until it snaps into position.
Endcap removed
A
0015
Working With Media and Cartridge(s)
Loading Media