Filter
Top Products
1-41
Company confidential. Murillo/Ravillo User’s Guide. Final Freeze Status: Frozen
This is the cyan on page 1-41 (seq: 59)
This is the black on page 1-41 (seq: 59)
Print Spooler Configuration Examples
Example 1: Configuring the SunOS 4.1.3 Print Spooler for Sun SPARCstations
(parallel interface)
In order to perform the following steps you must be a superuser.
1 Create a directory for print spooling. All application users need read and write
permission for this directory. For example, from the command line of a shell, type
mkdir /usr/spool/cad
chmod 777 /usr/spool/cad
2 Edit the /etc/printcap file to set up the plotter configuration. You must assign a
name to each printer or plotter managed by the print spooler. Refer to the example
below if you need help completing this step.
Add these lines to your
/etc/printcap file if:
your plotter is named
djet,
the device name of your parallel port is
/dev/bpp0, and
your spool directory is called
/usr/spool/cad.
# Entry for an HP plotter on a parallel port
djet:\
:mx#0:sf:sh:\
:lp=/dev/bpp0:\
:sd=/usr/spool/cad:\
:lf=/usr/adm/lpd–errs:
SETUP
1
Setting Up the Plotter
Extra Tips For UNIX Users