Filter
Top Products
3-6
Company confidential. Murillo/Ravillo User’s Guide. Final Freeze Status: Frozen
This is the cyan on page 3-6 (seq: 82)
This is the black on page 3-6 (seq: 82)
Combinations of Media Type and Print Quality
The table below shows that some combinations of media type and print quality are
not recommended.
Media Type on the
Front Panel Display
Print Quality
(Set Either on the Front Panel or In the Software)
Fast Normal Best
Opaque bond OK OK OK
Translucent bond OK OK OK
Translucent bond OK
in monochrome
only
OK
in monochrome
only
OK
in monochrome
only
Natural tracing paper OK OK OK
Vellum
OK
OK OK
Coated paper OK
OK
OK
Heavy coated paper OK OK OK
Matte film OK OK
OK
Clear film OK OK OK
High-gloss photo
Not
recommended
OK OK
Semi-gloss photo
Not
recommended
OK OK
High-gloss film
Not
recommended
OK OK
IMPORTANT If you are using an add-on a third-party Raster Image Processor (RIP), in order to
create additional print modes on your plotter, then the above table may not apply.
In this case, consult your RIP vendor for advice on the best settings for your re-
quirements. A clue as to whether you are using a RIP or not is the message on the
plotter’s front panel while it is printing. If the message
“STATUS / Printing (spe-
cial)”
appears, then you are using a RIP. If the message “STATUS / Printing”
appears, then you are probably not using a RIP.
Working With Media and Cartridge(s)
Choosing Media
700
750C Plus
750C Plus
750C Plus
750C Plus