Filter
Top Products
Back view of the HP All-in-One
1 Telephone wall jack
2 DSL filter and cord supplied by your DSL provider
3 Use the phone cord supplied in the box with the HP All-in-One to connect to the "1-LINE" port
To set up the HP All-in-One with DSL
1. Obtain a DSL filter from your DSL provider.
2. Using the phone cord supplied in the box with the HP All-in-One, connect one end
to your telephone wall jack, then connect the other end to the port labeled 1-LINE
on the back of the HP All-in-One.
Note If you do not use the supplied cord to connect from the telephone wall
jack to the HP All-in-One, you might not be able to fax successfully. This
special phone cord is different from the phone cords you might already have
in your home or office.
3. Connect the DSL filter cord to the telephone wall jack.
Note If you have other office equipment or services attached to this phone
line, such as a distinctive ring service, answering machine, or voice mail, see
the appropriate section in this section for additional setup guidelines.
4. Run a fax test.
Chapter 3
40 HP Photosmart C7100 All-in-One series
Fax setup