Filter
Top Products
To load 35 mm negatives
1. Raise the lid and remove the Slide and Negative Film holder and the lid backing.
Set the lid backing aside where it will not get damaged or dirty.
2. Unfold the holder so that the negative film portion is on top and the film opening is
on the right side.
3. Slide the negative film into the center of the holder so that the front of the image
faces away from you and appears backward.
4. Place the holder on the glass and match the bottom edge with the bottom edge of
the glass. Then, match the right tab on the top half of the holder with the right edge
of the glass.
5. Lower the lid of the HP All-in-One before starting the scan.
To load 35 mm slides
Note The HP All-in-One does not support scanning negative film that is mounted
as a slide in plastic or cardboard.
Basics Guide 59
Use the HP All-in-One features