Filter
Top Products
7. Ensure the end of the blue handle catches the wire loop on the near side of the carriage.
8. Lower the handle to rest on the carriage lid.
When all the printheads have been inserted correctly and are accepted by the printer, the printer
beeps.
NOTE: If the printer does not beep when you insert the printhead and the Replace message
appears on the front-panel display, the printhead may need to be reinserted.
9. Close the window.
10. The front-panel display confirms that all printheads are correctly inserted. The printer starts
checking and preparing the printheads. The default routine process, when all printheads are
changed, takes 25 minutes. If the printer finds problems in preparing the printheads, it takes
longer, up to 65 minutes. For a single printhead insertion, the times vary between 20 and 40
minutes. After all printheads are checked and prepared, the printhead realignment procedure
runs automatically if paper is loaded, see
Align the printheads on page 164.
114 Chapter 9 Handling ink cartridges and printheads ENWW
Ink and printheads