Filter
Top Products
178 Appendix B Control-panel menus ENWW
DIAGNOSTICS LOOPBACK
TEST
PING TEST
PING
RESULTS
YES
NO
DEST IP
PACKET
SIZE
TIMEOUT
COUNT
PRINT
RESULTS
EXECUTE
PACKETS
SENT
PACKETS
RECEIVED
PERCENT
LOST
RTT MIN
RTT MAX
RTT AVE
PING IN
PROGRESS
REFRESH
CAUTION This test will erase your TCP/IP
configuration.
YES the loopback test will be initiated.
NO the loopback test will not be initiated.
Specify the IP address of the remote host. A valid
IP address must be entered.
Specify the size of each packet, in bytes, to be sent
to the remote host. The minimum is 64 (default) and
the maximum is 2048.
Specify the length of time, in seconds, to wait for a
response from the remote host. The default is 1
and the maximum is 100.
Specify the number of pint test packets to send for
this test. Select a value from 1 to 100. To configure
the test to run continuously, select 0.
If the ping test was not set for continuous operation,
you can choose to print the test results. YES to print
results, NO to skip.
Specify whether to initiate the ping test. Select YES
to initiate, NO to skip.
Determines the number of packets (0-65535) sent
to the remote host since the most recent test was
initiated or completed.
Displays the number of packets (0-65535) received
from the remote host since the most recent test
was initiated or completed.
Displays the percent of ping test packets that wee
sent with no response from the remote host since
the most recent test was initiated or completed.
Displays the minimum detected round-trip-time
(RTT), from 0 to 4096 milliseconds, for packet
transmission and response.
Displays the maximum detected RTT, from 0 to
4096 milliseconds, for packet transmission and
response.
Displays the average detected RTT, from 0 to 4096
milliseconds, for packet transmission and response.
Displays whether or not a ping test is in progress.
YES indicates a test in progress, NO indicates that a
test completed or was not run.
Updates the ping test data with current results.
Item Options Values Explanation