Filter
Top Products
nugget
39
Learning About the Terminal
1-9
1
Charging the Battery Pack
You must fully charge the battery pack before you can use the terminal.
To charge the battery pack
•
Place the battery pack in an empty slot in the battery charger. The battery pack fully
charges in 3 to 4 hours. For help, see the documentation that came with your
charger.
•
Install the battery pack in the terminal. For help, see the next section, “Installing the
Battery Pack.” Connect one end of the AC power supply adapter cable to the AC
power supply, and connect the other end of the AC power supply adapter cable to
the power port on the 243X. The battery pack is fully charged in about 3 to 4 hours.
You can also use the powered vehicle dock (Part No. 071695) (sold and ordered
separately) connected to an external power supply to charge the battery. For help, see
the
Trakker Antares 243X Vehicle Dock Installation Instructions
(Part No. 071793).
Warning
Replace the battery pack with Part No. 068537 only. The use of any other battery
pack may present a risk of fire or explosion.
Avertissement
Remplacez le bloc-batterie par la pièce réf. n° 068537 seulement. L’utilisation de tout
autre bloc-batterie présente un risque d’incendie ou d’explosion.
Contact your local Intermec sales representative for a replacement battery pack.
DISPOSE OF USED BATTERY PACKS PROMPTLY. KEEP THEM AWAY FROM
CHILDREN.
Installing the Battery Pack
Note:
Do not press when there is no battery pack installed in the terminal.
To install the battery pack
1.
The 243X ships with the handstrap
installed. Before you install the
battery pack, you must remove the
handstrap. Rotate the handstrap hook
90 degrees, and unhook it from the
243X.
Handstrap
hook
243XU011.eps