Filter
Top Products
Trakker Antares 243X Hand-Held Terminal User’s Manual
nugget
39
1-22
Note:
If you have a long range or extra long range scanner, you may need hold the
terminal further away.
3.
Push the Scan button on the keypad or one of the side scan buttons on the terminal.
Direct the beam so that it falls across all bars in the bar code label. When the
terminal successfully reads the label, you will hear a high beep.
2435
*2435ROCKSs*
Side scan
button
(2 places)
Scan button
243XU009.eps
The green Good Read LED turns on when you successfully scan a bar code label
with the integrated scanner or an input device that is connected to the terminal. This
LED turns off after 2 seconds unless you start scanning another label.
4. Release the Scan button.
Note:
You can configure scanning options to scan multiple bar code labels without
pressing the Scan button each time. For help, see “Scanning Options” on page 1-24.
To successfully read a bar code label, the laser beam in the scan module must see all the
bars in a label and a clean, non-printed space, or “quiet zone,” at each end of the label.
*NANCY*
Quiet zone before and
after bar code
243XU098.eps