Filter
Top Products
Trakker Antares 243X Hand-Held Terminal User’s Manual
nugget
39
A-6
Input Devices and Cables
You must use an interface cable to connect an input device to the input device
connector. Use the following table to determine which non-decoded input device you
can attach to the 243X and which cable you need:
Non-Decoded Intermec Input Device Part No. Cable Part No.
1550C laser scanner 1550C0501 068424
1553E laser scanner 1550E0603 3-606031-00
1550C high visibility laser scanner 1550C0504 068424
1550C standard range laser scanner 1550C0500 068424
1551C standard range laser scanner 1551C0200 068424
1551E standard range laser scanner 1551E0600 Contact your Intermec
sales representative.
For a list of decoded input devices, contact your Intermec sales representative.
Note:
The 243X has two connector module options. The standard connector module
supports non-decoded input devices while the serial connector module supports decoded
input devices. Make sure that you select the appropriate input device for your connector
module. For help, see “Learning About the Connector Modules” in Chapter 1.
Intermec is constantly testing and developing new input devices. For an updated list of
Intermec-approved input devices for the 243X or for help determining which adapter
cable you need, see your Intermec sales representative.
Pin Assignments
You can use these pin assignments to make your own serial cables or troubleshoot
problems.
Pin Assignments for COM1
The following illustration shows the type of connector and the pin assignments for the
COM1 port.
1-TXD
3-GND
RTS-4
5-CTS
Charge in
(12 VDC)-6
RXD-2
243XU036.eps