Filter
Top Products
nugget
39
Configuring the Terminal
2-11
2
4. Choose Yes and press to save your changes in flash memory. The terminal
saves the current configuration as the active configuration. The Exiting TRAKKER
Antares 2400 Menu System screen appears.
Choose No and press to exit without saving. The terminal continues to use your
changes until you boot or reset the terminal. The Exiting TRAKKER Antares 2400
Menu System screen appears.
Choose Cancel and press to return to the Main Menu.
Exiting
TRAKKER Antares 2400
Menu System
243XU055.eps
OK CANCEL
5. Choose OK and press to exit the TRAKKER Antares 2400 Menu System.
Choose Cancel and press to return to the Main Menu.
After you exit the menu system, the terminal will resume the application you were
running when you started the menu system.
Configuring the Terminal With the Clone Application
The clone application uses
XMODEM-1K
protocol to copy configuration parameters and
applications from one 243X (server terminal) to another (client terminal). The server
and client terminals must have the same
•
hardware configuration.
•
version of firmware.
•
version of the clone application.
The clone application copies all configuration parameters, except for terminal IP
address, from the server terminal to the client terminal. You must configure the terminal
IP address separately. The clone application also removes all existing files on the client
terminal’s C drive, and replaces them with the files on the server terminal’s C drive.