Filter
Top Products
Trakker Antares 243X Hand-Held Terminal User’s Manual
nugget
39
1-10
2.
Open the battery door.
a.
Push down on the battery door latch
and slide it toward the bottom end of
the 243X.
b.
Lift up the bottom edge of the
battery door to remove it. You may
need to pry the door open with a
pointed object. Remove the foam
insert if necessary.
243XU015.eps
b.
a.
3.
Place the battery pack into the battery compartment with the contacts pointed
toward the bottom of the 243X.
4.
Push the battery pack down until it locks
into the connectors in the battery
compartment.
5. Insert the top edge of the battery door into
the top of the battery compartment. Push
the door down to close it over the battery
compartment.
6. Push the battery door latch up and slide it
toward the top end of the 243X to lock the
door in place.
The 243X initializes after you install a charged battery pack. The green LED above
the screen turns on briefly.
7.
Attach the handstrap by inserting the handstrap hook as shown and rotating the
handstrap hook 90 degrees toward the top of the terminal.
Handstrap
hook
243XU002.eps
Note:
The handstrap is most effective if it crosses the entire back of the hand and not
just the fingers.
243XU005.eps