Filter
Top Products
Trakker Antares 243X Hand-Held Terminal User’s Manual
nugget
39
4-18
Using the Boot Menu
To access the Boot menu, you can
•
upgrade the firmware. For help, see “Upgrading the Firmware” in Chapter 2 of the
2400 Family system manual.
•
reset the terminal. For help, see “Resetting the Terminal” on page 4-19.
•
remove the main battery and wait longer than 15 minutes to install a charged main
battery. This procedure also performs a destructive reset, which can have
unpredictable results.
The Boot Menu contains these commands:
Boot System Press to boot the terminal. Once
the terminal is finished booting, your application
appears on the screen.
Run Loader Press to load the terminal
firmware. To upgrade or load the firmware, use the
Firmware Upgrade option in the TRAKKER
Antares 2400 Menu System. For help, see Chapter 2
in the 2400 Family system manual.
Power Down Press to turn off the terminal.
When you turn on the terminal, the Boot Menu
screen appears again if POST passes.
Troubleshooting a Locked Up Application
If the terminal or application is locked up and the terminal will not respond to any key
sequences, try the following steps in order:
1. Press to turn off the terminal. Press to turn on the terminal.
2. Use the TRAKKER Antares 2400 Menu System to reboot the terminal.
a. Press or to enter the TRAKKER
Antares 2400 Menu System.
b. Choose System Menu and then Upgrade Firmware.
c. Choose OK, then YES, then press . The Boot Menu appears.
d. Press to boot the terminal.
BOOT MENU
1 - Boot System
2 - Run Loader
3 - Power Down
POWER DOWN IN 60 SEC
248XU104.eps