Filter
Top Products
Attaching the slide members to the library
To attach the slide members to the library, complete the following procedures:
1. Remove the inner slide member (1) from each rack-mount slide.
2. Attach the inner slide members to the sides of the chassis using eight hex
screws (2).
1 Inner slide member 8 Clip or cage nut (eight 8-32)
2 Hex screw (eight M4 x 8mm) 9 Screw (eight 10-32 x 5/8)
3 Front mounting bracket 10 Clip or cage nut (two 10-32)
4 Rear mounting bracket 11 Ball bearing slide member
5 Outer slide member 12 Sticker
6 Middle slide member 13 Thumbscrew (two 10-32)
7 Screw, flat washer, lock washer, nut (eight sets) 14 Door latch insert
Note: If you are installing the library on the IBM Netbay42 Enterprise rack, clip nuts (8 and 10) are provided. If
you are installing a Netbay11, Netbay25, or Netbay42 standard rack, cage nuts are provided.
Figure 11. Rack mounting the library
12 4560SLX Tape Library: User’s Guide