Filter
Top Products
4. Turn the primary chassis face down.
The belt block brackets and fasteners are now visible through the access
cutout.
5. Remove the four mounting screws from the two belt block brackets as shown
in Figure 73.
6. Turn the primary chassis face up and remove the belt from the media elevator
car and the tensioner ramp/idler pulley.
7. Remove the belt tensioner components as shown in Figure 74 on page 79.
a. Remove the two screws and springs from tensioner ramp/idler pulley.
b. Remove the other two screws from the tensioner ramp/idler pulley.
c. Remove the tensioner ramp/idler pulley.
Figure 72. Tensioner ramp/idler pulley zero point
Figure 73. Cartridge elevator belt block and brackets
78 4560SLX Tape Library: User’s Guide