Filter
Top Products
In order to use Web TLC, you must have the following:
v A 10 BaseT Ethernet network
v A dedicated IP address (either Internet or local)
v A host computer with COM port (initial setup and alternative maintenance
procedures only)
v Access to your network
v A web browser installed on your computer (either Microsoft Internet Explorer
3.0 or higher or Netscape 3.0 or higher)
Operation
This section explains the functionality that is available on Web TLC but not always
found on deployed hardware systems. To configure Web TLC you must utilize
Network Options on the touch screen or set the IP addresses. See “Setting IP
addresses” on page 55.
Web TLC access
To access Web TLC:
Note: The library must be in ready mode to establish communications with Web
TLC. If you are unable to access the unit with your browser, check whether
the library is being operated locally.
1. Type the Web TLC IP address in the Location field of your Internet browser,
and press Enter.
Serial
Configuration
Cable
Hub
Figure 59. Local area network
64 4560SLX Tape Library: User’s Guide