Filter
Top Products
3. Push the middle slide member as far as possible to the front of the slide
member assembly.
Installing a library in the rack
To install a library in the rack, complete the following procedure:
1. Install a clip or cage nut on each side of the front vertical rails as shown in
Figure 14.
2. Lighten the library module by removing the drives.
3. Lift the library and visually align the inner and middle slide members. (It is
good practice to use a mechanical lifter to lift the library.)
4. Carefully insert the chassis inner slide members into the extended
rack-mounted middle slide members. Ensure that the ball bearing slide
members are located in the front position.
5. Slide the library completely into the rack until the front panel touches the
rack.
6. Remove the stickers that hold the doors in a closed position.
7. With the doors open, attach the library to the rack using two 10-32 captive
thumbscrews (located on the front panel inside the front doors). (See 1 and
2 in Figure 15 on page 15.)
1 Clip or cage nut
2 Vertical member mounting holes
Figure 14. Installing the library module
14 4560SLX Tape Library: User’s Guide