Filter
Top Products
Installing the cartridge elevator
To install the cartridge elevator, complete the following procedure:
Note: The following procedure assumes that the modules have been prepared for
rack-mount installation or are installed in a rack.
1. Ensure that the router is mounted at the top of the rack.
2. If modules are rack-mounted, verify that all units are powered down and the
power cords are removed.
Note: Attempting to install the cartridge elevator to a fully powered 4560SLX
Tape Library module might cause severe damage to unit circuitry.
3. Remove drive shoe 2 as shown in Figure 66 on page 73 or the blank cover for
each module that will use the cartridge elevator.
Figure 65. Cartridge elevator router installed
72 4560SLX Tape Library: User’s Guide