Filter
Top Products
2. Position the router at the top rear of the rack to locate the appropriate
mounting holes in the rack rails.
3. Install the four captive fasteners into the rack rails.
4. Mount the router using the four screws (10-32x 1/2 P.H.). Do not apply power
or connect any cables.
5. You have received a pre-assembled 10U cartridge elevator. If the length is
correct for your system, proceed to “Installing the cartridge elevator” on
page 72. If you need to add an extension to your system, proceed to “Cartridge
elevator extension assembly” on page 75.
1567
WAN
432
1 Mounting holes
2 10BaseT connection ports
3 Host port
4 COM port (factory use only)
5 Power switch
6 ac power
Figure 64. Cartridge elevator router
Appendix B. Adding a library module 71