Filter
Top Products
j. After you change the last label, the Change Description Label Locations
display appears with the updated information. A message at the bottom
of the display indicates whether the last change was successful. If
More... appears on the bottom of the display, scroll forward to view
more information.
k. Press the F17 key on the Change Description Label display to request a
printout of the new information for your records.
Note: The printout will be in the default output queue for your
workstation. You can print it later when you vary on your printer
devices and start printer writers.
l. Verify that the labels on the printout match the labels in the Label
column on your source system. If you find any errors, go back to step 9f
on page 30 and repeat the steps.
Attention: Do not exchange cards for problem analysis purposes. Card
and device serial numbers are tied to the system configuration.
__ 10. The Change Description Label Locations display appears. Determine whether
the new target system has more storage or communications lines than the
source had. If so, use the Work Management book to check the work
management objects and tune the system performance.
__ 11. Perform a normal IPL. SRC A900 2000 should not appear on the control
panel when the IPL completes.
__ 12. Save the entire system just after the hardware upgrade is done. Use option
21 on the Save menu. For more information about saving the entire system
using option 21, refer to any of the following:
v The chapter on saving your AS/400 system in the book Backup and
Recovery, SC41-5304-04
v The Backup, Recovery, and Availability topic under System
Administration, Availability, and Maintenance in the Information
Center:
http://www.as400.ibm.com/infocenter
To find the procedure for saving the entire system (using option 21) in
the Information Center, do the following:
a. Click System Administration, Availability, and Maintenance
b. Click Backup, Recovery, and Availability
c. Click Backing up your system
d. Click Saving your system with the GO SAVE command
e. Click Saving your whole system with GO SAVE: Option 21
__ 13. Resume normal operations and verify that all your applications run
properly.
__ 14. Generate reports of the hardware and configuration objects (for each
partition) by issuing the following commands:
DSPHDWRSC TYPE(*LWS) OUTPUT(*PRINT)
DSPHDWRSC TYPE(*STG) OUTPUT(*PRINT)
DSPHDWRSC TYPE(*CMN) OUTPUT(*PRINT)
DSPHDWRSC TYPE(*PRC) OUTPUT(*PRINT)
DSPPTF LICPGM(*ALL) OUTPUT(*PRINT)
__ 15. Print a new system configuration list using Start a service tool option.
a. Do the following on the AS/400 Main menu command line:
Type Start System Service Tools (STRSST).
Press the Enter key.
Chapter 3. Procedure for an Upgrade (RISC-to-RISC) 31