Filter
Top Products
– TCP command mode protocol
– Service location protocol
v
From the Security page, you can install and configure the Secure Sockets Layer
(SSL) settings.
v From the Configuration File page, you can back up, modify, and restore the
configuration of the Remote Supervisor Adapter II.
v From the Restore Defaults page, you can reset the Remote Supervisor Adapter II
configuration to the factory defaults.
v From the Restart ASM page, you can restart the Remote Supervisor Adapter II.
Setting system information
To set the Remote Supervisor Adapter II system information, complete the following
steps:
1. Log in to the Remote Supervisor Adapter II where you want to set the system
information. For more information, see Chapter 2, “Opening and using the Web
interface,” on page 5.
2. In the navigation pane, click System Settings. A page similar to the one in the
following illustration is displayed.
Note: The available fields in the System Settings page are determined by the
accessed remote server.
3. In the Name field in the ASM Information area, type the name of the Remote
Supervisor Adapter II.
Use the Name field to specify a name for the Remote Supervisor Adapter II in
this server. The name is included with e-mail, SNMP, and alphanumeric pager
alert notifications to identify the source of the alert.
Notes:
a. If you plan to set up an SMTP server for e-mail alert notifications, make sure
that the name in the Name field is valid as part of an e-mail address (for
example, there are no spaces).
b. Your Remote Supervisor Adapter II name (in the Name field) and the IP host
name of the Remote Supervisor Adapter II (in the Host Name field on the
Network Interfaces page) do not automatically share the same name
because the ASM Name field is limited to 15 characters. The Host Name
12 Remote Supervisor Adapter II SlimLine and Remote Supervisor Adapter II: User’s Guide