Filter
Top Products
Chapter 5. Performing Remote Supervisor Adapter II tasks
Use the functions under the Tasks heading in the navigation pane to directly control
the actions of the Remote Supervisor Adapter II and your server. The tasks that you
can perform depend on the server in which the Remote Supervisor Adapter II is
installed.
You can perform the following tasks:
v View server power and restart activity
v Remotely control the power status of the server
v Remotely access the server console
v Remotely attach a disk or disk image to the server
v Update the Remote Supervisor Adapter II firmware
v Access other Remote Supervisor Adapter IIs and Remote Supervisor Adapters
Note:
Some features are available only on servers running a supported Microsoft
Windows operating system.
Server power and restart activity
The Server Power/Restart Activity area displays the power status of the server
when the Web page was generated.
Power The Power field shows the power status of the server at the time this Web
page was generated.
State The State field shows the state of the server when the Web page was
generated. The following states are possible:
v System power off/State unknown
v System in POST
v System stopped in POST (Error detected)
v Booted Flash or System partition
v Booting OS or in unsupported OS (could be in the operating system if
the operating system or application does not report the new system
state)
© Copyright IBM Corp. 2003, 2007 79