Filter
Top Products
1) In the Microsoft Windows Control Panel, click Add/Remove Hardware;
then, click Next.
2) Select Uninstall/Unplug a device; then, click Next.
3) Click Unplug/Eject a device; then, click Next.
b. Select USB Mass Storage Device and click Stop.
c. Click Close.
d. In the Remote Control window, click Unmount Drive.
Setting up PXE network boot
Note: The PXE network boot feature is not available on all servers.
Complete the following steps to set up your server to attempt a Preboot Execution
Environment (PXE) network boot at the next server restart:
1. Log in to the Remote Supervisor Adapter II. For more information, see
Chapter 2, “Opening and using the Web interface,” on page 5.
2. In the navigation pane, click PXE Network Boot. A page similar to the one in
the following illustration is displayed.
3. Select the Attempt PXE network boot at next server restart check box.
4. Click Save.
Serial redirection quick setup
Note: This feature is not available on the Remote Supervisor Adapter II SlimLine in
some servers.
You can use the Remote Supervisor Adapter II Web interface serial redirection
wizard to simplify the configuration of serial redirection.
To use the serial redirection wizard, complete the following steps:
1. Log in to the Remote Supervisor Adapter II. For more information, see
Chapter 2, “Opening and using the Web interface,” on page 5.
2. In the navigation pane, click Serial Redirect. A page similar to the one in the
following illustration is displayed.
86 Remote Supervisor Adapter II SlimLine and Remote Supervisor Adapter II: User’s Guide