Filter
Top Products
Table 4-3 (Page 7 of 13). Firmware Checkpoints
Checkpoint
(hex)
Description Repair Action
E180 SP Command setup See “Unresolved problems” on page 4-26
E183 SP Post See “Unresolved problems” on page 4-26
E190 Create ISA node See “Unresolved problems” on page 4-26
E193 Initialize Super I/O See “Unresolved problems” on page 4-26
E196 Probe ISA bus See “Unresolved problems” on page 4-26
E19B Create Service
Processor node
See “Unresolved problems” on page 4-26
E19C Create tablet node See “Unresolved problems” on page 4-26
E19D Create nvram node See “Unresolved problems” on page 4-26
E19E RTC node creation
and initialization
Refer to Error Code 28030xxx
E19F Create eeprom node See “Unresolved problems” on page 4-26
E1AD See description of
checkpoint E1DE.
See “Unresolved problems” on page 4-26
E1B0 Create lpt node Replace System Planar
See “Unresolved problems” on page 4-26
E1B1 Create serial node See “Unresolved problems” on page 4-26
E1B2 Create audio node Replace System Planar
See “Unresolved problems” on page 4-26
E1B3 Create 8042 node Replace System Planar
See “Unresolved problems” on page 4-26
E1B6 Probe for (ISA)
keyboard
Replace System Planar
See “Unresolved problems” on page 4-26
E1BA Enable L2 cache See “Unresolved problems” on page 4-26
E1BB Set cache parms for
burst
See “Unresolved problems” on page 4-26
E1BC Set cache parms for
512KB
See “Unresolved problems” on page 4-26
Chapter 4. Error Code to FRU Index for the Model 150 4-19