Filter
Top Products
Step 1540A-11
The system is working correctly with this configuration. One of the FRUs (adapters)
that you removed is probably defective,
1. Turn the power off.
2. Install a FRU (adapter) and connect any cables and devices, if any, that were
attached to it.
3. Turn the power on.
4. Make sure the diagnostic CD-ROM disc is inserted into the CD-ROM drive.
5. If the Console Selection screen is displayed, choose the system console.
6. After the keyboard indicator is displayed, press the F5 key on the
directly-attached keyboard or the number 5 key on an ASCII terminal keyboard.
7. Enter the appropriate password when prompted to do so.
Is the "Please define the System Console" screen displayed?
NO Go to “Step 1540A-12” on page 2-34.
YES Repeat this step until all of the FRUs (adapters) are installed, then go to
the
Repair Checkout Procedure
in the
Diagnostics Information for Multiple
Bus Systems
.
Chapter 2. Maintenance Analysis Procedures (MAPs) 2-33