Filter
Top Products
Chapter 4 - Configuring Impulse with Application Developer
4-7
Mechanics window C will appear if you select Non-IDC Mechanics from the “system” list.
• Enter your Total System Inertia (Load + Mechanics + Motor).
• Select your Move Unit (steps, revs, mm, or inches) from the pulldown menu.
• Enter your Distance Ratio (only if inches or mm are the selected Move Units). You cannot
enter Distance Ratio if either steps or revs has been selected.
4. Click Next and the Resolution setup window will appear
• Select your Step Resolution from the pulldown menu, or enter a step resolution in incre-
ments of 200.
5. Click on Next and the I/O (Input/Output) setup window will appear. Using the pulldown menus,
select configurations for up to four (4) Discrete Inputs and one (1) Discrete Output. The buttons
to the right of the inputs and outputs are provided for toggling between Active High (A.H.) and
Active Low (A.L.).
C