Filter
Top Products
Ingenico 6500 User’s Guide 45
6.4.9 Setting the Poll Timeout
Poll Timeout is the amount of time the host waits for a response after transmitting a device poll
before it records a device poll timeout, in units of one-tenths of a second.
This time varies. It depends on the number of devices connected to the host system. The more
devices connected to the host, the longer it takes the host to poll each device. If the PIN pad
device misses more than 16 consecutive polls, the host will abandon the device.
Display Action
To access the extended menu, restart the terminal
by pressing [1] + [CAN] + [OK]; while the terminal
is starting up, access the extended menu by
pressing the [1] and [3] keys simultaneously.
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Press [], [], [], [Enter] to select Supervisor
Menu.
Enter Password:
Key password [2] [6] [3] [4], then press [Enter].
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Press [], [], [], [Enter] to select Sys
Parameters.
Sys Parameters
Download Method
Download Port
Setup Port
Press [], [], [Enter] to select Setup Port.
Setup Port
Port1
Port2
Select Port1 or Port2.
(By default, Port 1 = Host, Port 2 = Aux.)
Port X
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
LAN Address
Retry Count
Response TMO
Poll TMO
Press [] seven times, and then press [Enter] to
select Poll TMO (timeout).
Poll TMO
Old Value: 300
Enter New Value:
Enter an amount of time after which the port
should cease polling, in units of 1/100 of a second.