Filter
Top Products
Intel® NetStructure™ ZT 8101 10/100 Ethernet Switch User’s Manual 123
Using the Web Console
To configure member ports of an 802.1Q VLAN
1. In the left panel, click VLAN Configurations.
2. In the top panel, click
IEEE 802.1Q Port Settings.
3. For each port, enable or disable the following:
4. Click
Apply.
GMRP
GMRP (Group Multicast Registration Protocol) allows ports to dynamically join multicast groups.
It provides a mechanism that allows bridges and end-stations to dynamically register (and
subsequently, de-register) group membership information with the MAC bridge attached to the
same LAN segment. By default, this flag is disabled.
To configure GMRP globally:
1. In the left panel, click VLAN Configurations.
2. In the top panel, click
Switch GMRP.
3. Use the drop-down menu to select
Enabled or Disabled.
4. Click
Apply.
To configure port GMRP settings
1. In the left panel, click VLAN Configurations.
2. In the top panel, click
Port GMRP Settings.
3. Select and configure these fields:
4. Click
Apply.
5. To change an entry, repeat steps 3-4.
To configure VLANs supporting GMRP
1. In the left panel, click VLAN Configurations.
2. In the top panel, click
Configure VLANs Supporting GMRP.
Field Description
GVRP
Specifies whether the port can dynamically become a member of a VLAN.
This protocol allows the port to share VLAN information with other ports so
that a VLAN can span multiple switches.
Ingress Checking
Specifies whether a port checks the VID of incoming packets against its VID
or PVID. If the two are equal, the port will receive the packet. It the two are
unequal, the port will drop the packet. This is used to limit traffic to a single
VLAN.
Field Description
Port Specifies which port to configure (1-26).
GMRP State Specifies the state (off or on) of GMRP for this port.