Filter
Top Products
Intel® NetStructure™ ZT 8101 10/100 Ethernet Switch User’s Manual 125
Using the Web Console
To configure link aggregation load sharing
1. In the left panel, click Link Aggregation Settings.
2. In the top panel, click
Load Sharing Algorithm.
3. Select a load sharing algorithm from the following:
4. Click
Apply
Layer 3 - IP Networking
This section describes how to configure
• IP interfaces
• RIP
• Multicast routing protocols
Setting Up IP Interfaces
Each IP interface on the switch corresponds to a VLAN. A VLAN, which does not have a
corresponding IP interface defined for it, will function as a Layer 2-only VLAN.
The switch allows ranges of IP addresses (OSI Layer 3) to be assigned to VLANs (OSI Layer 2).
Each VLAN must be configured prior to setting up the corresponding IP interface.
Column Description
Master
Specifies which member port is the master port. The master port is always
the lowest numbered port. All member ports are configured to use its settings
and become members of its VLAN.
Note: This value will not be displayed on an LACP trunk until it is negotiated
with the aggregation partner.
Anchor
Specifies which member port is the anchor port. The anchor port is
responsible for the flooding of multicast frames and for sending control
packets.
Note: This value will not be displayed on an LACP trunk until it is negotiated
with the aggregation partner.
Field Description
Src Address Load sharing based on Layer 2 MAC Source Address (SA)
Dst Address Load sharing based on Layer 2 MAC Destination Address (DA)
Src & DST Address
Load sharing based on Layer 2 MAC Source and Destination Address (XOR
of SA and DA)
Src IP Load sharing based on Layer 3 IP Source Address (SIP)
Dst IP Load sharing based on Layer 3 IP Destination Address (DIP)
SRC & DST IP
Load sharing based on Layer 3 IP Source and Destination Address (XOR of
SIP and DIP)