Filter
Top Products
Intel® NetStructure™ ZT 8101 10/100 Ethernet Switch User’s Manual 59
Using the Telnet Console
3. In the Path\Filename field, enter the path on the TFTP server and the filename.
4. Highlight
SAVE SETTINGS and press Enter. This saves the information so that the next time
you access this screen, you won’t have to enter the address or the path\filename.
5. To start the file transfer to the TFTP server, highlight
UPLOAD and press Enter.
To test connectivity with ping
1. From the Main Menu, select Switch Utilities | Ping Test and press Enter.
2. Configure these fields.
3. To start the test, highlight
START and press Enter.
BOOTP/DHCP Relay
BOOTP/DHCP relay agent enables end stations to use a BOOTP or DHCP server to obtain TCP/IP
configuration information or boot files to be loaded into memory, even if the servers are not on the
local IP interface. The following conditions determine whether you need to enable BOOTP/DHCP
relay:
• If the BOOTP or DCHP server and end station are on the same IP interface, no relay agent is
necessary.
• If the servers and the end stations are on different IP interfaces, a relay agent is necessary for
the switch to forward the messages.
The relay agent forwards these packets between IP interfaces, and therefore must know the IP
addresses of the BOOTP and DHCP servers and their respective subnet names (or IP interface
names).
When the switch receives packets destined for a BOOTP or DHCP server, it forwards them to
specific servers as defined in the following configuration. The switch also forwards packets from
the BOOTP or DHCP servers to the appropriate subnets.
To enable the BOOTP/DHCP relay agent
1. From the Main Menu, select Switch Utilities | BOOTP/DHCP Relay and press Enter.
Field Description
IP Address Specifies the IP address of the network device to ping.
Number of Repetitions Specifies the number of test packets to send. Three is the usual number.
Default timeout Specifies the number of seconds to wait between sending the packets.