Filter
Top Products
80 Intel® NetStructure™ ZT 8101 10/100 Ethernet Switch User’s Manual
Using the Telnet Console
4. Highlight APPLY and press Enter.
5. To enter the change into non-volatile RAM, highlight
Save Changes from the Main Menu and
press
Enter.
To configure the member ports of an 802.1Q VLAN
1. From the Main Menu, select VLAN Configurations | IEEE 802.1Q Port Settings and press
Enter.
2. Highlight the Configure Port field and enter the range of port numbers you want to configure.
To configure a single port, enter that port number in both the To and From field.
3. Configure these fields.
4. Highlight
APPLY and press Enter.
Link Aggregation
Link aggregation allows several ports to be grouped together so that they can act as a single port.
This is done to either increase the bandwidth of a network connection or to increase fault tolerance.
Link Aggregation is most commonly used to link a bandwidth-intensive network device or devices
—such as a server or server farm—to the backbone of a network.
You can configure up to six aggregation groups, each using from two to eight ports between any
two ZT 8101 switches or other devices that support 802.1ad Link Aggregation.
To configure a link aggregation group
1. From the Main Menu, select Link Aggregation and press Enter.
2. Configure these fields.
Field Description
Ingress Checking
Enables or disables ingress filter checking. Ingress filtering allows the port
to compare the VID tag of an incoming packet with the PVID number
assigned to the port. If the two are different, the port filters (drops) the
packet. Use the spacebar to toggle between On and Off.
GVRP
Enables or disables GVRP (GARP VLAN Registration Protocol). This allows
the switch to share VLAN information with other switches so that a VLAN
can span multiple switches.
Field Description
Group ID
Specifies one of the six possible link aggregation groups configurable on the
switch.