Filter
Top Products
48 Intel® NetStructure™ ZT 8101 10/100 Ethernet Switch User’s Manual
Using the Telnet Console
• 9,600 baud
• 8 data bits
• No parity
• One stop bit
• No flow control
See chapter 2 for instructions on logging in using this serial connection.
You can also access the same interface with a Telnet application. Once you have set an IP address
for your switch, you can use a Telnet program (in VT-100 compatible terminal mode) to access and
control the switch. All of the screens are identical, whether accessed from the serial port or from a
Telnet application.
To log in to the switch the first time
These instructions describe how to log in to the switch using a Telnet application. The passwords
used to access the switch are case sensitive; therefore, “S” is not the same as “s.” The factory
default IP address for the switch is 10.90.90.90.
1. From a computer attached to the same network as the switch, open a command window.
2. In a command window, enter Telnet <IP_address>.
Replace <IP_address> with the address assigned to the switch.
3. In the Username field press Enter. There is no initial username.
4. In the Password field, press Enter. There is no initial password. The Main Menu appears.
The first created user automatically has Admin privileges. One of your first configuration tasks
should be to create at least one Admin-level user for the switch to protect it from unauthorized
users.
Press CTRL+R to refresh the screen. This command can be used at any time to force the console
program in the switch to refresh the console screen.
Note: If the arrow keys don’t work, check your terminal preferences and make sure you have enabled VT
100 Arrows.
Main Menu
The Main Menu has these options.