Juniper Networks E-Series Network Router User Manual


 
Telnet Setup
E-Series Routers
8-5
Before you can access the system with Telnet, you must either configure a
password for Telnet access or disable the password requirement from the
management console. In the following example, you disable the
password.
1 Enter the enable command.
host1>enable
host1#
The system is now in Privileged Exec mode.
2 Enter the configure command.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
The system is now in Global Configuration mode.
3 Enter the line command.
host1(config)#line vty 0 4
host1(config-line)#
The system is now in Line Configuration mode.
4 Disable the password.
host1(config-line)#no login
Note: In this example, you disabled the password requirement, but you can
choose to set a password instead. See the E-Series System Basics Configuration
Guide, Chapter 6, Passwords and Security for information on setting a password.
5 Run Telnet from a host on the same Ethernet network as the system.
6 Enter the IP address of the system to open the Telnet session.
The User Exec prompt appears when the Telnet session to the system
is established.
host1>
7 Enter the enable command.
host1>enable
host1#
The system is now in Privileged Exec mode.
8 Enter the configure command.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#