Juniper Networks E-Series Network Router User Manual


 
CHAPTER 5
Installing Modules
5-16
Verifying the Installation
To verify that the installation is complete:
1 After you have cabled the system for power (see Chapter 6, Cabling
E-Series Routers), turn on the power switches.
The system reboots.
2 Issue the show redundancy command, and verify that the display
shows the redundancy hardware.
Configuring Line Module Redundancy
For information about configuring line module redundancy, refer to
E-Series System Basics Configuration Guide, Chapter 5, Managing Line
Modules and SRP Modules.
The Next Step
After you install the modules, you can connect cables to the system. Turn
to Chapter 6, Cabling E-Series Routers.