Juniper Networks E-Series Network Router User Manual


 
CHAPTER 12
Module Specifications
12-22
FE
FE-2
I/O
Non-ASIC ERX-7xx models
ERX-1410 router
SRP-5G
SRP-5G+
SRP-10G
2 RJ-45 For 10-Mbps operation, use CAT
3, 4, or 5 UTP cable.
For 100-Mbps operation, use only
CAT 5 UTP cable.
The transmitted signal complies
with IEEE 802.3/802.3u for cable
lengths up to 100 m
(328 feet).
FE-8
I/O
ASIC ERX-7xx models
ERX-14xx models
ERX-310 router
SRP-5G+
SRP-10G
SRP-40G
SRP-40G+
SRP-SE10G
8 RJ-45 For 10-Mbps operation, use CAT
3, 4, or 5 UTP cable.
For 100-Mbps operation, use only
CAT 5 UTP cable.
The transmitted signal complies
with IEEE 802.3/802.3u for cable
lengths up to 100 m
(328 feet).
GE
GE
I/O
SFP
b,c
ASIC ERX-7xx models
ERX-14xx models
ERX-310 router
SRP-5G+
SRP-10G
SRP-40G
SRP-40G+
SRP-SE10G
1 active
1 redundant
LC full duplex •Tx power:
min: –9.5 dBm
max: –4 dBm
Center wavelength: 850 nm
Rx input power:
min: –17 dBm
max: –3 dBm
Rated for 275 m (300 yards) over
62.5-micron core cable
Rated for 550 m (601 yards) over
50-micron core cable
Table 12-3 I/O module specifications (continued)
I/O Module Label
a
Type
Model
Compatibility
SRP Module
Compatibility
No. of
Ports
Connector Type Cabling Specifications