Juniper Networks E-Series Network Router User Manual


 
CHAPTER 6
Cabling E-Series Routers
6-8
Figure 6-3 ERX-310 router SRP I/O module
See Chapter 8, Accessing E-Series Routers, for more information about
management access.
Connecting to the Network
To connect the E-series router to the network:
1 Insert an Ethernet cable (RJ-45) connector into the 10/100Base-T
(RJ-45) port on the SRP I/O module until it clicks into place.
2 Connect the other end of the cable to the appropriate Ethernet
network for an out-of-band connection.
Connecting to a Console Terminal
When you connect a console directly to the E-series router SRP I/O
module, use a cable appropriate for your terminal connector. The cable
must have a female DB-9 connector to attach to the RS-232 port on the
SRP I/O module.
To connect the console to the SRP I/O module:
1 Insert the female DB-9 connector into the RS-232 port, and tighten
the screws.
2 Connect the other end of the cable to your terminal’s serial port
(VT100/ANSI).
RS-232 10/100
BASE T
SRP I/O module
g013751