Juniper Networks E-Series Network Router User Manual


 
5
Installing Modules
This chapter describes how to install and remove E-series modules.
For information about managing installed modules, see E-Series System
Basics Configuration Guide, Chapter 5, Managing Line Modules and
SRP Modules.
Overview
Line module slots are located in the front of each E-series chassis, while
I/O module slots are located in the rear. See Chapter 1, E-Series
Overview, for front and rear views of E-series routers.
In ERX-14xx models, modules mount vertically in a chassis with 14 slots.
In ERX-7xx models and ERX-310 routers, modules mount horizontally
in a chassis with 7 slots and 3 slots, respectively. See Figure 5-1.
Topic Page
Overview 5-1
Safety Guidelines 5-7
Installing SRP I/O and SRP Modules 5-7
Installing Line and I/O Modules 5-10
Removing a Module 5-11
Installing Components for Line Module Redundancy 5-13
Configuring Line Module Redundancy 5-16
The Next Step 5-16