Filter
Top Products
Chapter 8---Software and Protocol
8-10 Model 250 Service Manual
8.3 Terminals and Communication Protocols
Terminals
The projector can be controlled by a VT-100 terminal. If a VT-100 is not
available, a PC with Windows 3.1 or ProComm for DOS can emulate a VT-100.
Table 8-1 shows the equivalent commands for the terminal and both remotes.
1. From Windows Program Manager, select TERMINAL then SETTINGS.
2. Select TERMINAL EMULATION from SETTINGS menu.
3. Select DEC VT-100 (ANSI) (may already be selected).
4. Use a Null Modem cable to connect between the projector and the
terminal.
5. Use the TERMINAL PREFERENCES and COMMUNICATIONS
PROTOCOL below for Windows setup.
Terminal Preferences
Select SETTINGS again from the menu bar. Select TERMINAL
PREFERENCES. Set the following modes:
Table 8-1
Terminal preference settings
Line Wrap Yes CR
"
CR/LF:
Local Echo No Inbound No
Sound Yes Outbound No
Columns: Cursor:
80: Yes Block: Yes
132: No Underline: No
Blink: Yes
Terminal Font: Translations NONE
Courier 12 IBM to ANSI No
Terminal Show:
Scroll Bars Yes Buffer Lines 100
Use Function Arrow
and Control keys for
Windows No