Filter
Top Products
Chapter 5---Electronics
5-10 Model 250 Service Manual
Controller PCB also enables the selected VICs through the IIC bus based on the
VIC selected on the Channel Menu.
The System Controller PCB generates the on-screen menus and test pattern
overlays and sends them to the Video Processor PCB. It sends the X and Y
Convergence correction data to the Convergence Deflection PCB. It sends
Threshold and Sensitivity shading data to the Video Processor PCB for the all
three colors. The System Controller PCB stores all the configuration data such as
Geometry, Convergence, Shading, ILA
®
Bias and Sensitivity, and G2 settings etc.
in flash memory and allows that data to be exported to, or imported from a floppy
disk.
The System Controller PCB displays system status through a single three-color
LED visible on the back panel. A green light indicates normal operation, the
yellow indicates standby operation, and red indicates a fault or error condition.
The System Controller PCB has an External Service Mode Switch that enables the
operator to switch from the normal operating mode to a diagnostic mode. If there
is a new release of system software, it can be uploaded into the projector by
switching into the diagnostic mode. The procedure for this is in the Software and
Protocol section (see Chapter 8, Software and Protocol).
System Controller PCB - Remove and Replace
Tools Needed
#1 Pozi-drive Phillips-head screwdriver
#0 Pozi-drive Phillips-head screwdriver
Parts Needed
System Controller PCB - p/n 104678
To remove the System Controller PCB:
1.
Power OFF the projector by IR Remote or PC, and allow the cooling fans
to run until they shut off automatically.
2.
Turn the AC Circuit Breaker to the OFF position and unplug the AC
Power Cord.
3.
Disconnect all the external source video cables and control cables.
4.
Remove the rear cover.
5.
Remove the Back Panel. Remove the nine Pozi-drive Phillips-head
retaining screws using the #1 Pozi-drive Phillips screwdriver.
6.
Remove the Connector Bracket by removing the single Pozi-drive
Flathead Phillips-head screw using the #0 Pozi-drive Phillips screwdriver.
7.
Pull the black Card Extractor handles back to disconnect the System
Controller PCB connector and pull the PCB out of the Electronics Module.
8.
Reverse the procedure to install the System Controller PCB.