Filter
Top Products
Regulatory compliance
FCC statement
The United States Federal Communications Commission (in CFR 47 Part 15.105) has specified that the following
notice be brought to the attention of the users of this product:
: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the product into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
:
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this product not expressly approved
by Eastman Kodak Company might cause harmful interference and void the FCC authorisation to operate
this product. The radiated energy from this product is well below the FCC radio frequency exposure limits.
Nevertheless, the product shall be used in such a manner that the potential for human contact during normal
operation is minimised. This product and any attached external antenna, if supported, shall be placed in such
a manner as to minimise the potential for human contact during normal operation. In order to avoid the
possibility of exceeding the FCC exposure limits, human proximity shall not be less than 20 cm (8 inches)
during normal operation.
Canadian statements
This product meets the applicable Industry Canada technical specifications.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
Industry Canada (IC) Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20 cm between the radiator and your person.
European compliance statement
Hereby, Eastman Kodak Company declares that this KODAK all-in-one wireless printer is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
Product and Safety Specifications
90 www.kodak.com/go/aiosupport