Filter
Top Products
January 10, 2006 5E6155 3-1
3
Operation and Maintenance
System Power Up, Shut Down, and Energy Save
Power Up To power up the laser imager, press and hold the power switch to the ON
position for about 2 seconds. The green indicator light above the local
panel glows when the power is on.
The power up process takes approximately 3 minutes. After power up, the
laser imager begins accepting and queueing print jobs. At this point, you
can determine cartridge status and load new cartridges if necessary.
Film will not begin processing until the laser imager is completely warmed
up (approximately 45 minutes).
Power Switch (press for two seconds)