Filter
Top Products
Operation and Maintenance
January 10, 2006 5E6155 3-23
Operator Maintenance
Cleaning the Laser Imager Clean the outside surfaces of the laser imager as necessary. Use a soft cloth
with warm water and mild soap.
CAUTION
:
Do not use isopropyl alcohol to clean the exterior surfaces
of the laser imager. Isopropyl alcohol can dissolve the
exterior paint on the laser imager.
Installing a New Charcoal
Filter
A charcoal filter is in a filter holder that is mounted behind the lower right
front door of the laser imager.
Install a new filter after every 20,000 film cycles.
NOTE: Authorized Service Providers of Kodak products routinely install
new filters during the 20,000 film cycle Preventive Maintenance
procedure. You only need to change filters if you do not have
Kodak’s Preventive Maintenance Plan.
CAUTION:
Filters are considered to be non-hazardous waste according
to the US Environmental Protection Agency Resource
Recovery Act. You may dispose of the filters in a landfill or
incinerator with energy recovery in a municipal, commercial
or industrial facility. Contact your state or local government
to determine if additional disposal requirements apply.