Filter
Top Products
A-61560 June 2006 25
The main Kodak Scanner window will be displayed.
NOTE: When you access the main Kodak Scanner window, refer to
Chapter 4, Image Processing for more information on how to get
started using the TWAIN datasource or ISIS driver.
4. Select Defaults. A confirmation message, Reset all values to
factory defaults will be displayed.
5. Click OK. This resets the software to the factory-installed default
settings. The factory default settings are set to capture color
images.
6. Place some test documents into the input tray of the scanner.
7. Click the Start button on the Scan Validation Tool dialog box. The
documents will be scanned and displayed in the Scan Validation
Tool window. Be sure that one of the window display icons is
selected, otherwise the scanned image will not be visible.
NOTE: If the scanner is in lamp saver mode, a message will be
displayed that the lamps need sufficient time to warm up.
After the images have been displayed, your scanner installation
verification is completed.
8. Click the Close box to exit the Scan Validation Tool.
Window
display icons